44102 Grip 2000 KG FULLY WELDED HYDRAULIC BOTTLE JACK

APPLICATION 

• Bottle style hydraulic jack for the lifting of vehicles or other heavy components and/ or equipment so that maintenance can be performed.

FEATURES 

• Heavy duty steel construction, fully seam welded base and top cap for superior leak resistance 

• Fully machined steel (not cast iron) heavy duty base plate

• Quality chrome hydraulic ram and piston pump 

• Black baked enamel finish for corrosion resistance 

• Australian Standard compliance 

SAFETY NOTICE 

• The jack should be used on hard, level surfaces 
• The wheels of the vehicle to be chocked
• Do NOT put a portion of your body under a vehicle supported by a jack 
• No person should remain in a vehicle that is being jacked 
• Do NOT exceed working load limit 

SPECIFICATIONS 

• Working load limit : 2000kg
• Minimum height : 193mm
• Maximum height : 368mm
• Hydraulic lift height: 116mm
• Screw height adjustment : 60mm
• Base plate dimensions : 110(L) x 100(W) x 170(H)mm
• Australian Standard : AS/NZS 2693:2007
• Packaged dimensions : 128(L) x 118(W) x 210(H)mm
• Packaged weight (net) : 4 kg 

Please note: Vertical lifts only, if jack is tilted to any angle other than vertical position from base plate the hydraulic system will not operate 

MAINTENANCE NOTE 

• It is recommended that the oil level should be approximately 3mm below the oil filler hole.
• To add oil lower the jack to the lowest position, then remove the air vent valve, add oil to the desired level, pump 5 or 6 times to expel any air in the cylinder, and then fasten the air vent valve. DO NOT USE BRAKE FLUID, ALCOHOL, GLYCERINE, DETERGENT, MOTOR OIL OR DIRTY OIL.