44104 Grip 4000KG FULLY WELDED HYDRAULIC BOTTLE JACK

 APPLICATION 

• Bottle style hydraulic jack for the lifting of vehicles or other heavy components and/or equipment so that maintenance can be performed 

FEATURES 

• Heavy duty steel construction, fully seam welded base and top cap for superior leak resistance 

• Fully machined steel (not cast iron) heavy duty base plate 

• Quality chrome hydraulic ram and piston pump 

• Black baked enamel finish for corrosion resistance 

• Australian Standard compliance 

SAFETY NOTICE 

• The jack should be used on hard, level surfaces 
• The wheels of the vehicle to be chocked 
• Do NOT put a portion of your body under a vehicle supported by a jack 
• No person should remain in a vehicle that is being jacked 
• Do NOT exceed working load limit 

SPECIFICATIONS 

• Working load limit: 4000kg
• Minimum height: 212mm
• Maximum height: 407mm
• Hydraulic lift height : 118mm
• Screw height adjustment: 70mm
• Base plate dimensions: 120(L) x 110(W) x 170(H)mm
• Australian Standard: AS/NZS 2693 : 2007

Please note: Vertical lifts only, if jack is tilted to any angle other than vertical position from base plate the hydraulic system will not operate. 

MAINTENANCE NOTE 

• It is recommended that the oil level should be approximately 3mm below the oil filler hole 
• To add oil lower the jack to the lowest position, then remove the air vent valve, add oil to desired level, pump jack 5 or 6 times to expel any air in the cylinder, and then fasten the air vent valve.  Use only ISO10-S hydraulic fluid .DO NOT USE BRAKE FLUID, ALCOHOL, GLYCERINE , DETERGENT, MOTOR OIL OR DIRTY OIL.