44106 Grip 6000KG FULLY WELDED HYDRAULIC BOTTLE JACK

APPLICATION 

Bottle style hydraulic jack for the lifting of vehicles or other heavy components and/or equipment so that maintenance can be performed 

FEATURES 

• Heavy duty steel construction, fully seam welded base and top cap for superior leak resistance 

• Fully machined steel (not cast iron) heavy duty base plate 

• Quality chrome hydraulic ram and piston pump 

• Black baked enamel finish for corrosion resistance 

• Australian Standard compliance 

SAFETY NOTICE 

• The jack should be used on hard, level surfaces 
• The wheels of the vehicle to be chocked 
• Do NOT put a portion of your body under a vehicle supported by a jack 
• No person should remain in a vehicle that is being jacked 
• Do NOT exceed working load limit 

SPECIFICATIONS 

• Working load limit : 6000kg
• Minimum height : 230mm
• Maximum height: 455mm
• Hydraulic lift height : 127mm
• Screw height adjustment: 80mm
• Base plate dimensions: 120(L) x 110(W) x 170(H)mm
• Australian Standard : AS/NZS 2693: 2007
• Packaged dimensions: 135(L) x 135(W) x 240(H)mm
• Packaged weight (net) : 7kg

Please note: Vertical lifts only, if jack is tilted to any angle other than vertical position from base plate the hydraulic system will not operate 

MAINTENANCE NOTE 

It is recommended that the oil level should be approximately 3mm below the oil filler hole. 

To add oil lower the jack to the lowest position, then remove the air vent valve, add oil to desired level, pump jack 5 or 6 times to expel any air in the cylinder, and then fasten the air vent valve.  Use only ISO10-S hydraulic fluid. DO NOT USE BRAKE FLUID, ALCOHOL, GLYCERINE, DETERGENT, MOTOR OIL OR DIRTY OIL